How to Remove 3M Adhesive Stickers

Removing 3M adhesive tap could be as easy as peeling it off. However, if the tape has a solid adhesive, or it has been long been sitting on the wall or elsewhere, it might leave behind a sticky residue. 3m adhesives are very helpful as they are used as post-it notes, scotch tapes for binding things together, etc. But, removing the adhesive can prove to be a hassle. As the residue leaves behind dirt and dust that can damage the walls.

Door Stop With 3M Adhesive

There are several door stop with 3M Adhesive available to purchase now as they are:

  • Made from stainless steel, with strong rubber on its base to prevent the door or the wall from damaging.
  • No screws or drilling are needed, as it attaches directly to your wall due to the strong 3M adhesive that makes it easier to securely stick the door stop to your wall.
  • The door stop serves as a wall-mounted stopper but can be mounted on the floor as well.

Removing the door stop with 3M adhesive can turn out to be quite difficult than sticking it directly to the wall. White foam backed 3M tapes are always much harder to remove than grade grey tape which are fairly easier to remove even upon heating.

By following these various steps, you can easily remove 3M adhesive from the walls, plastics, or anywhere else.

Steps to Remove 3M Adhesive

Even though it is easier to stick anything using 3M adhesives, but removing it can prove to be quite a task as it leaves behind a strong residue. Below are some techniques on how to remove 3M adhesives from any surface:

Step 1: Peeling Off From Hand

Peeling off the tape gradually by pulling off from each corner towards the center of the tape will limit the amount of solid residue from being left out on the taped material.

Step 2: Heat

While pressing another piece of tape over the adhesive may help remove more residue rather than all of it. In order to avoid damaging the plaster on the wall try applying Heat to a 3M tape. By using a hair dryer and blowing hot air on the tape, it will soften the adhesive and make it easier for the tape to come off without sticking to the material. Afterwards, use an object with sharp edges to scrape off the rest of the residue easily.

Step 3: Adhesive Removers

There are adhesive remover which help in removing 3m tape from any surface, glass, plastic, walls, and such. Using a citrus-based cleaner can also help remove the adhesive easily, after allowing it to stick on it for several minutes. It fully removes the adhesive from the surface. Check out our powerful adhesive remover here. You can use this discount code to claim 10% off the normal full price! (code: REMOVER10).


3M adhesives are easy and simpler to use, but it is not a daunting task to remove them. Even if the glue does not come off through heat, a number of adhesive removal products are available to make it easier to remove the residue.

The Dove Factor™ Adhesive Remover


Get yours at the link below, using REMOVER10 to get a 10% discount off your purchase.

Leave a comment

Please note, comments must be approved before they are published